Radiana, the solution to cooler rooms at your fingertips
The Radiana ceiling panel uses radiant cooling to act as a heat exchanger between the room and the cold water running through the panels. The ceiling absorbs heat from sources in a room and exchanges it to chilled water circulating through panels. The chilled water is then delivered to a chiller and re-cooled.
An integrated smart solution
…consists of a 37.5mm thick pre-formed EPS board and a plasterboard panel bonded together and is very easy to install and maintain. The panel can be cut to size to fulfil almost any building requirement. Cutting is as simple as cutting plasterboard. There are no fans involved so the panel is silent and does not collect or move dust.
…integrates a unique technology to modulate radiant fluid technology to modulate radiant fluid temperatures so that surfaces stay above dew point. It controls energy resources (heat pumps, chillers and boilers) with multi-staging, Domestic Hot Water, Heat Recovery Ventilation based on Indoor Air Quality and Neutral Temperature Dehumidification. The system can be controlled by your phone using the Radiana app.
The Radiana App
…gives you full control of the radiant cooling and heating system from anywhere in the world. It features a friendly and intuitive user interface to control this sophisticated system and fits seamlessly into your life to provide the perfect Thermal Wellbeing™, precisely when and where you want it.
Radiana’s easy 6-step installation guide
Radiana is extremely easy to install. It is installed directly to the framing in much the same way as traditional plasterboard, in 6 easy steps.
Lifting and Positioning
Modular panels make lifting and positioning with a plasterboard lifter safe and simple.
Hanging the Panels
No additional structure required – panels are installed on a standard metal frame or timber joist ceiling.
Radiana’s patented 3 o-ring push fit connector is already installed in the panel make the joining of panels seamless and risk free.
Panels are anchored to the frame using standard 100mm drywall screws. The pipes are laser etched on the panel so that it is clear where to insert the fixings.
Panels have a taper edge finish to enable standard tape joint procedure.
Once tape jointing or skimming is complete the panels can be decorated in the normal manner.